This is a relatively small update, but I got a lot done. I will go into detail on the steps more later when I do the other side.

I assembled the rear suspension, and checked out my radiator choice.

1. Here are both halfshafts all assembled. It just took pressing the u-joints in.		2. Here is the radiator I was going to use.
3. Here is the one I will use. The frame rails are 6 inches higher than final here.		4. This is a straight comparison of the two next to each other.
5. Suspension arm hanging off, and halfshaft attached.		6. All on and propped up with a piece of wood. Looks very Jaguary.
7. Poking out from the body work, all sexy like.		8. I even put a mockup wheel on.
9. Another view. The wheel well will be bigger, round, and have an inch or two of flare.

© 2003 Brownie Davis All Rights Reserved