Motor Mounts.

This just shows some welding I did on the motor mount pedestals.

1. They are made out of some thick roud tube with 2x2 square tubing cut to fit.		2. At this point they are just tacked together.
3. Still tacked. Different angle.		4. I tried to weld in stages so the metal didn't get too hot.
5. One all welded up on the inside.		6. They were strong enough welded on the inside, but I decided to weld the outside to make it look better.
7. The welds are a little lumpy, but they are strong.

© 2003 Brownie Davis All Rights Reserved