|
It's been a bit since I've updated, and this is some misc things that I've done lately.
This is in preparation for more things to come.
1. I took off the remnant of the inner fender that I always tear my clothes on. |
|
2. And the same on the passenger side. |
3. I also procured a crank pulley/damper from a front wheel drive SR, to match my alternator. |
|
4. Here is the engine sans crank pulley. |
5. Original pulley on the right, FWD pulley on the left. |
|
6. A comparison of size. Original left, FWD right. |
7. New pulley on the engine. Makes it a bit shorter. |
|
8. Old one sitting on the crossmember. |
9. Tranny offset. |
|
10. Front end with rotisserie mount. |
11. One more. |
|
12. Minus the mount. Those were not the final frame rails,and other things may still change. |
13. Ready to take the engine out again to redo the mounts a third time. |
|
14. Frame rails and rough cut extensions. |
15. Amazing how much oil is still in the pan after all this time. |
|
Hopefully on the road to progress again. Onward and Upward.
|
