|
I had some fun mounting the manifolds, and transfering some hardware.
This was so I could design my firewall and passenger footwell panels.
1. This is my greddy knockoff manifold. |
|
2. This is my stock manifold. |
3. Here they are next to each other. the new manifold is considerably smaller than the old one. |
|
4. Old manifold stripped of injectors. |
5. New manifold with injector bungs in. |
|
6. Old rail in place on new manifold. At this point it is not sitting flush and level. |
7. And here is why. This and another tab are in the way. |
|
8. I will have some cleaning up to do inside the manifold. |
9. Now with fuel rail sitting as it should. |
|
10. One tab I cut off. |
11. And the other. This tab ends up not being used at all. |
|
12. Manifold mounted to engine. |
13. Original cut was to fit original manifold, and even more would have to be cut now. |
|
14. Exhaust header/manifold in place.. |
15. This is a T3 from a Volvo. It will need to be clocked and modified a little. |
|
16. Oil drain pipe off. Mounted to my engine, this sits paralell to the ground. |
17. My turbo with the internal wastegate removed. |
|
18. Both sides set in place. You can see the turbo is just mocked into place. |
19. Turbo set in place and held with a bungee cord. |
|
20. Another angle. |
21. The exhaust will have to run here between the passenger compartment and the transmission |
The manifolds were put into place in order to see where the firewall and passenger foot wells can go.
More cutting and welding soon.
|
