I found some seats that should be great for the car, but I may have to change my plans a bit.

These are from an 80's BMW 325i sedan and I found them at the junkyard.


1. On first inspection, they look like they will fit.
  
2. The floor will have to be widened, and the tranny is a bit far over to the passenger side.

3. In fact, it's wedged in a bit against the tranny.
  
4. Another shot.

5. That shows how much it needs to go over.
  
6. Last one. Will summarize my conclusions below.

What to do? I will have to drop the floor so that they do not sit too high, take off a lot of their trim bits, and for this and other reasons, center the tranny and move the enging forward a bit...
   

 

© 2003 Brownie Davis All Rights Reserved